Sub-Millisecond Mixing in a T-Mixer in the Turbulent Flow Regime: Quantitative Chemiluminescence-Based Analysis

30 May 2025, Version 1
This content is a preprint and has not undergone peer review at the time of posting.

Abstract

Microreactors have been widely used in recent years for the development of new organic reactions and precise material synthesis, leveraging rapid mixing for reaction control. Among these, T-shaped mixers are widely employed due to their simple and cost-effective configuration. However, quantitative insights into mixing behavior in practical condition with high Reynolds number regime (Re>500) are limited. This issue becomes especially important when scaling up laboratory-scale reactors, where the impact of increased mixer diameter on mixing performance must be evaluated. In this study, we used a T-mixer of an equivalent diameter of 500 µm and measured mixing times under high flow rate conditions up to total flow rate of 160 mL/min using the chemiluminescence reaction of luminol. By using a larger diameter mixer, we achieved extremely short mixing times of 0.3 ms while keeping pressure loss to about 500 kPa. This mixing time is sufficiently rapid for utilizing short-lived intermediates in organic synthesis reactions. Our discovery provides practical guidelines for quick utilization of intermediates and high-throughput processes in organic synthesis reactions.

Keywords

Chemiluminescence
Flow reactor
Turbulent flow
Mixing rate

Comments

Comments are not moderated before they are posted, but they can be removed by the site moderators if they are found to be in contravention of our Commenting Policy [opens in a new tab] - please read this policy before you post. Comments should be used for scholarly discussion of the content in question. You can find more information about how to use the commenting feature here [opens in a new tab] .
This site is protected by reCAPTCHA and the Google Privacy Policy [opens in a new tab] and Terms of Service [opens in a new tab] apply.