Chemical Engineering and Industrial Chemistry

Ender3 3D Printer Kit Transformed into Open, Programmable Syringe Pump Set

Vittorio Saggiomo Wageningen University and Research

Abstract

Ender 3 syringe pumps is an open source and open hardware device for converting an Ender 3 kit to a set of 3 syringe pumps. Almost everything needed for the build is the Ender 3 kit, even all the screws and the tools needed for the assembly. The only parts which needed to be bought are three 5x5 shaft couplers and M5 lead screw.

Version notes

version 1.0

Content

Thumbnail image of Preprint Ender Pumps.pdf
download asset Preprint Ender Pumps.pdf 0.41 MB [opens in a new tab]

Supplementary material

Thumbnail image of Ender 3 Syringe Pump Build Guide v0.1.pdf
download asset Ender 3 Syringe Pump Build Guide v0.1.pdf 3 MB [opens in a new tab]
Ender 3 Syringe Pump Build Guide v0.1
Thumbnail image of Steps mL Calculation.xlsx
download asset Steps mL Calculation.xlsx 0.01 MB [opens in a new tab]
Steps mL Calculation
Thumbnail image of videoS1 - Edited - Large 540p.mov
download asset videoS1 - Edited - Large 540p.mov 48 MB [opens in a new tab]
videoS1 - Edited - Large 540p
Thumbnail image of VideoS2 - Edited - Large 540p.mov
download asset VideoS2 - Edited - Large 540p.mov 16 MB [opens in a new tab]
VideoS2 - Edited - Large 540p
Thumbnail image of VideoS3 - Edited - Large 540p.mov
download asset VideoS3 - Edited - Large 540p.mov 23 MB [opens in a new tab]
VideoS3 - Edited - Large 540p